Complete The Parts Replacement - Lenovo ThinkSystem ST50 V2 Maintenance Manual

1. If an M.2 drive was removed, reinstall the M.2 drive, see
Note: The thermal sensor cable should be placed under the M.2 drive.
2. Reinstall the front fan, see
3. Reinstall the front bezel, see
4. Proceed to complete the parts replacement, see

Complete the parts replacement

To complete the parts replacement, do the following:
1. Ensure that all the removed components have been reinstalled correctly and that no tools or loose
screws are left inside the server.
2. Ensure that the CMOS battery is installed on the system board, see
on page 47.
3. Properly route and secure the cables in the server. Refer to the cable connecting and routing information
for each component.
4. Reinstall the server cover, see
5. If the server was removed from the rack previously, put it back into the rack, see
rails" on page 139.
6. Reconnect external cables and power cords to the server.
Attention: To avoid component damage, connect all the other cables before connecting the power
cords.
7. Update the server configuration if necessary.
• Go to https://datacentersupport.lenovo.com/tw/en/products/servers/thinksystem/st50v2/downloads/
to see the latest firmware and driver updates for your server.
driver-list/
• Go to "Update the firmware" on page 8
ThinkSystem ST50 V2 Maintenance Manual
158
"Install the fan (front and rear)" on page
"Install the front bezel" on page
"Complete the parts replacement" on page
"Install the server cover" on page
for more information on firmware updating tools.
"Install an M.2 drive" on page
81.
85.
"Install the CMOS battery (CR2032)"
146.
105.
158.
"Install the server to the