Remove The M.2 Drive Retainer - Lenovo ThinkSystem ST50 V2 Maintenance Manual

Watch the procedure
A video of this procedure is available at YouTube:
AU3iY3F7lq3qfqr5caGbIu
About this task
Step 1. Make sure the 2.5-drive is removed from drive bay 2, see
on page 50.
Step 2. Make sure the post on the M.2 drive retainer is lifted away from the retainer.
Step 3. Install the M.2 drive.
Note: The thermal sensor cable should be placed under the M.2 drive.
a. Position the M.2 drive at an angle and insert it to the M.2 connector.
b. Place down the M.2 drive onto the M.2 drive retainer.
c. Insert the retainer post into the retainer to secure the M.2 drive in place.
Figure 84. Installing the M.2 drive
After you finish
1. If necessary, reinstall the 2.5-inch drive to the drive bay 2, see
page 53.
2. Proceed to complete the parts replacement, see

Remove the M.2 drive retainer

Follow this procedure to remove the M.2 drive retainer.
ThinkSystem ST50 V2 Maintenance Manual
106
.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
"Remove a simple-swap drive (bay 1-2)"
"Install a simple-swap drive (bay 1-2)" on
"Complete the parts replacement" on page 158.