Lenovo ThinkSystem ST50 V2 Maintenance Manual page 106
Hide thumbs
Also See for ThinkSystem ST50 V2:
- Setup manual (122 pages) ,
- Quick start (2 pages) ,
- Maintenance manual (192 pages)
Table of Contents
Advertisement
Figure 76. Tightening the screws on the heat sink and fan module for processor with 95W TDP
Step 4.
If the server is installed with processor with 95W TDP, the heat sink fan should be installed on the
rear side of the chassis. Align the four fan screws to the screw holes on the rear side of the chassis,
and fasten the screws to secure it.
Figure 77. Installing the heat sink fan to the rear of the chassis
Step 5.
Connect the heat sink fan cable to the system board, see
ThinkSystem ST50 V2 Maintenance Manual
98
"Internal cable routing" on page
19.
Advertisement
Table of Contents
