Lenovo ThinkSystem ST50 V2 Maintenance Manual page 74

After you finish
1. Install the optical drive cage, see
2. Connect the signal and power cable to the system board, see
3. Complete the parts replacement, see
4. Check the drive activity LED on the front panel to verify if the drives are operating correctly.
Table 29. Drive activity LED behavior
Status
Solid on
Off
5. Use the Lenovo XClarity Provisioning Manager Lite to configure the RAID if necessary. For more
information, see
https://sysmgt.lenovofiles.com/help/topic/LXPML/RAID_setup.html
Remove the drive cage (bay 3)
Follow this procedure to remove a simple-swap drive cage from bay 3.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
• Read "Safety inspection checklist" on page iv
work safely.
• Turn off the server and peripheral devices, and disconnect the power cords and all external cables, see
"Power off the server" on page
• If the server is in a rack, remove it from the rack. See
ThinkSystem ST50 V2 Maintenance Manual
66
"Install the optical drive cage" on page
"Complete the parts replacement" on page
Color Description
White The drives are active.
None The drives are not active.
9.
"Internal cable routing" on page
and "Installation guidelines" on page 41
"Remove the server from the rails" on page
77.
19.
158.
.
to ensure that you
137.