Table of Contents
Advertisement
Watch the procedure
A video of this procedure is available at YouTube:
AU3iY3F7lq3qfqr5caGbIu
About this task
Step 1.
Make sure the 2.5-drive is removed from drive bay 2, see
on page
50.
Step 2.
Make sure the post on the M.2 drive retainer is lifted away from the retainer.
Step 3.
Install the M.2 drive.
Note: The thermal sensor cable should be placed under the M.2 drive.
a.
Position the M.2 drive at an angle and insert it to the M.2 connector.
b.
Place down the M.2 drive onto the M.2 drive retainer.
c.
Insert the retainer post into the retainer to secure the M.2 drive in place.
Figure 85. Installing the M.2 drive
After you finish
1. If necessary, reinstall the 2.5-inch drive to the drive bay 2, see
page
53.
2. Proceed to complete the parts replacement, see
Remove the M.2 drive retainer
Follow this procedure to remove the M.2 drive retainer.
.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
"Remove a simple-swap drive (bay 1-2)"
"Install a simple-swap drive (bay 1-2)" on
"Complete the parts replacement" on page
.
Chapter 3
Hardware replacement procedures
158.
107
Advertisement
Table of Contents
