Wiring And Configuration - Omron DeviceNet DST1 Series Operation Manual

7-1 Wiring and Configuration

7-1 Wiring and Configuration
The following table shows input device connection methods and configuration.
Connected
device
Reset switch Connect the switch between IN0 and T0.
Connect the switch between 24V DC and IN0.
Emergency Connect the switches between IN0 and T0, and IN1
stop switch and T1.
Door monitor
Connect the switches between T0 and IN0, IN.
Connect the switches between 24 V DC and IN0,
IN1.
Safety Connect OSSD1 and OSSD2 to IN0 and IN1,
Light Curtain respectively.
7-2
Schematic diagram
IN0 T0 IN1 T1
IN0 T0 IN1 T1
24V
IN0 T0 IN1 T1
IN0 T0 IN1 T1
IN0 T0 IN1 T1
24V
IN0 T0 IN1 T1
Configuration
Safety Input used as "Single Channel input" without
test output.
Test output used as power supply output.
Safety Input used as "Single Channel input" without
test output.
Safety Inputs used as "Dual Channel input" with test
output.
Test outputs used as "Pulse Test Output".
Safety Inputs used as "Dual Channel input" with test
output.
Test output used as "Pulse Test Output".
Safety Inputs used as "Dual Channel input" without
test output.
Safety Inputs used as "Dual Channel input" without
test output.