Test Outputs - Omron DeviceNet DST1 Series Operation Manual

1-3-3

Test Outputs

Item
Test output mode Any of the following five modes can be selected according to the external input
device.
Output status after Sets the output state of the test output when a communications error occurs.
communications This parameter is enabled when the Test Output Channel Mode is set to Standard
error Output or Muting Lamp Output.
Short-circuit Supported.
detection
Broken wire Supported.
detection of This setting is valid when Test Output Mode is set to Muting Lamp Output.
external indicator
Not Used The corresponding test output is not used.
Standard Output Specifies connecting to the input for a muting lamp or PLC.
Used as a monitor output.
Pulse Test Specifies connecting a device with a contact output in
Output combination with the safety input.
Power Supply Specifies connecting to the power supply terminal of a safety
Output sensor. The voltage supplied from the test output to the I/O
power supply (V, G) is output.
Muting Lamp Specifies a muting lamp output.
Output When the output is ON, disconnection of the muting lamp can be
(terminal T3 detected.
only)
Description
1-3 Functions
1-9