5-2 Safety I/O Terminal With Semiconductor Outputs; Safety Input Specifications; Test Output Specifications; Safety Output Specifications For Semiconductor Outputs - Omron DeviceNet DST1 Series Operation Manual

5-2 Safety I/O Terminal with Semiconductor Outputs
5-2-1

Safety Input Specifications

The following table gives the safety input specifications for the DST1-MD16SL-1.
Item
Input type
ON voltage
OFF voltage
OFF current
Input current
5-2-2

Test Output Specifications

The following table gives the test output specifications for the DST1-MD16SL-1.
Item
Output type
Rated output current
Residual voltage
Leakage current
5-2-3

Safety Output Specifications for Semiconductor Outputs

The following table gives the safety output specifications for the Semiconductor outputs
on the DST1-MD16SL-1.
Item
Output type
Rated output current
Residual voltage
Leakage current
IMPORTANT In case that a safety output is configured as Safety pulsed test, while this output is
ON
OFF

5-2 Safety I/O Terminal with Semiconductor Outputs

Sinking input (PNP)
11 VDC min.
5 VDC max.
1 mA max.
6 mA
Sourcing output (PNP)
0.7 A
1.2 V max.
0.1 mA max.
Sourcing output (PNP)
0. 5 A
1.2 V max.
0.1 mA max.
in an ON state, the signal sequence shown below is output continuously to enable
diagnosis. Confirm the response times of the devices connected to the safety
outputs so that the devices do not malfunction due to the OFF pulse.
470 us
typical
Specifications
Specifications
Specifications
648 ms
typical
5-5