Initialize Mode - YASKAWA CIMR-MC5A20P4 Instruction Manual

Setting User Constants

4.2.5 Initialize Mode

EXAMPLE Changing Monitor Display to Output Current at Startup in Basic Access Level
A "
4
4.2.5 Initialize Mode
Use the following procedure to change user constant o1-02 so that the output current is displayed at startup.
(The procedure continues from the end of the previous example.)
Step Key Sequence
1
2
3
DATA
ENTER
4
Press twice.
5
DATA
ENTER
6
ESC
7
ESC
Output current has been set in monitor selection after power ON.
The initialize mode is used to select the language displayed by the Unit, the access level, and the control
method; it is also used to initialize the Unit's user constants. The structure of the initialize mode is shown
in Figure 4.7.
Operation mode
MENU
Initialize mode
Programming mode
Fig
4.7 Structure of Initialize Mode User Constants
Digital Operator Display
User Monitor Sel
Output kWatts
Power-On Monitor
Frequency Ref
o1- -02 = 1
Frequency Ref
o1--02 = 3
Output Current
Entry Accepted
Power-On Monitor
Output Current
Function o1
Monitor Select
MC5 Main Menu
Programming
Language
Access level
Control mode
Initialize
Password
Function Selection A2
Accessible/settable only in Advanced setting level.
- 18
Remarks
Check the display.
Writes-in the new setting.
After a few seconds, the Operator dis-
play is as shown on the left.
A2-01 User Pram 1
A2-02 User Pram 2
A2-32 User Pram 32