Switching Modes - YASKAWA CIMR-MC5A20P4 Instruction Manual

4.2.2 Switching Modes

Once the Inverter has been put into operation mode by pressing the Menu Key, the Increment and Decre-
ment Keys can be pressed to switch to other modes. Press the DATA/ENTER Key to read/set the user
constants in each mode.
Press the ESC Key to return to the mode display from the user constant display.
Press the DATA/ENTER Key twice to write a constant and then press the ESC Key to return to the mode
display. This is the most Basic operation, so you should remember it.
All modes/constant
status
MENU
Operation mode
MC5 Main Menu
Operation
Initialize mode
MC5 Main Menu
Initialize
Programming mode
MC5 Main Menu
Programming
Autotuning mode
(Open loop vector control at factory
setting.)
MC5 Main Menu
Autotuning
Modified constant mode
MC5 Main Menu
Modified Consts
(Mode Display)
IMPORTANT IMPORTANT
When running the Inverter after using digital operator, press the MENU Key to enter the operation mode and
then press the DATA/ENTER Key from the operation mode display to bring up the monitor display. Run com-
mands cant't be received from any other display. (Monitor display in the operation mode appears when the
power is turned ON.)
Power ON
DAT Monitor (Frequency reference value)
A
ENTER
Frequency Ref
U1- -01 = 0.00 HZ
ESC
DAT Operator display language selection
A
ENTER
Select Language
English
ESC
Frequency reference input method
selection
Display contents differ depending on the
access level (A1-01)
DAT
A
ENTER
Reference Source
Terminal
ESC
(Access level: Quick-start)
Autotuning
(Rated voltage setting)
DAT
A
ENTER
Rated Voltage
200.0 VAC
ESC
Displays constants changed
from factory settings
DAT
A
ENTER
None Modified
ESC
Function
(Constant Reading)
Fig
4.3 Mode Transitions
- 5
DAT
A
ENTER
A1- -00 = 1
English
ESC
DAT
A
ENTER
Function b1
Sequence
ESC
DAT
A
ENTER
Rated Voltage
200.0 VAC
ESC
Constant Display
(Constant Setting)
4.2 Modes
4