Furuno DUAL GPS GP-150-DUAL Operator's Manual page 85

DATA1 output setting
1) Press MENU ESC, 9 and 3 keys to show the DATA1, 3 OUTPUT SETUP
menu.
2) Press
3) Press
4) Press the CU/NU ENT key. Talker ID appears in reverse video.
5) Press
6) Press the CU/NU ENT key.
7) Enter TX interval for each output data sentence in line 1. TX interval is
available in 00, 01, 02, 03, 04, 05, 06, 10. 15, 20. 30, 60 and 90 sec.
8) Press the MENU ENT key.
9) Enter TX interval for each output data sentence in lines 2 through 5. Press
the CU/NUENT key after setting each line.
In great circle calculation, BWC and WNC are output but BWR and WNR are not.
In rhumb line navigation, BWR and WNR are output but BWC and WNC are not.
The total data output are shown by percentage on the third line.
For best results the total output should be less than 90%; lengthen the Tx
interval of less important data to make the total output less than 90%.
DATA 1, 3 OUTPUT SETUP
Data FMT V1.5
Talker ID GP
Output Data (00-90 sec)
1. AAM:00 APA:00
2. BWC:00 BWW:00 GGA:01 GLL:01
3. RMB:01 RMC:00 VTG:01 WCV:00
4. VDR:00 WPL:00 XTE:00 ZDA:01
5. GNS:00 GBS:01 Rnn:00 RTE:00
DATA3. Log Pulse
ENT : Enter
This line appears only when LOG is
selected by internal jumper blocks.
Settings shown above are default settings.
DATA1, 3 OUTPUT SETUP menu
to select DATA FMT.
or to select V1.5, V2.0 or IEC.
or to select GP, LC or DE.
IEC
V2.0
LC DE
82%
APB:04 BOD:00
200ppm
400ppm
MENU : Escape
10. INSTALLATION
TX rate of operation
10-13