Furuno DUAL GPS GP-150-DUAL Operator's Manual page 79

How to attach the N-P-8DFB connector
Outer Sheath
Armor
50
Cover with heat-shrink tubing and heat.
30
Clamp
Nut
Clamp Nut
Inner Sheath Shield
30
10
Clamp
Gasket
(reddish
brown)
Aluminum Foil
Trim shield here.
Insulator
Trim aluminum
tape foil here.
1
5
Pin
Shell
Solder through
the hole.
10. INSTALLATION
Remove outer sheath and armor by the
dimensions shown left.
Expose inner sheath and shield by the
dimensions shown left.
Cut off insulator and core by 10mm.
Twist shield end.
Slip on clamp nut, gasket and clamp as
shown left.
Fold back shield over clamp and trim.
Cut aluminum foil at four places, 90°
from one another.
Fold back aluminum foil onto shield and
trim.
Expose the insulator by 1mm.
Expose the core by 5mm.
Slip the pin onto the conductor. Solder
them together through the hole on the
pin.
Insert the shell into the pin. Screw the
clamp nut into the shell.
(Tighten by turning the clamp nut. Do
not tighten by turning the shell.)
10-7