Turning On And Off The Power - Furuno DUAL GPS GP-150-DUAL Operator's Manual

1. OPERATIONAL OVERVIEW
1.2 Turning On and Off the
Power
The GP-150-DUAL takes about 90 seconds
to find its position when turned on for the very
first time. Other times it takes about 12
seconds.
Note: The GPS provides highly accurate
position information. However, position
should always be checked against
other aids to navigation to confirm
reliability, for the safety of vessel and
crew.
Turning on the power
Press the POWER key.
The unit tests the Program Memory, SRAM
and battery for proper operation and shows
the results on the display. If equipped with the
internal beacon receiver, "Beacon RCVR
Installed" appears at the bottom of the display.
After the test has been completed, the unit
starts up with the last-used display mode.
Program Memory = OK
SRAM
Internal Battery
Beacon RCVR Installed
DATA 3 : Data Output
Several seconds
later
34˚ 23.456´ N 135˚ 45.678´ E
30
40
H
20
TM W84
2.00NM
Figure 1-2 Appearance of display when
turning on the power
1-2
= OK
= OK
GPS receiving
condition
D3D 100m
* SAFE
BRG
35.0˚
[01]
COG
7.0˚
50
RNG
123
NM
SOG
12.3
kn
When turning on the power the following
occurs:
12 seconds after turning on the power,
accurate position (in latitude and longitude)
appears on the display.
If position could not be found, "NO FIX" blinks
at the GPS receiving condition window. When
PDOP (Position Dilution Of Precision) value
exceeds 6 in the 3D mode or HDOP
(Horizontal Dilution Of Precision) value
exceeds 4 in the 2D mode, "DOP" blinks to
indicate abnormal fixing and the position
indication is not updated.
When the satellite signal is being received
normally, one of the indications shown in
Table 1-1 appears depending on equipment
setting and GPS receiver state.
Table 1-1 GPS receiver indication
Indication
2D
3D
D2D
D3D
W2D
W3D
Note 1: When PDOP value exceeds 6 in the
3D mode, the position fixing method
is automatically changed to 2D.
Note 2: The "DEMO" icon appears when the
display is in the demonstration mode.
To return to the normal mode, turn
off the power and turn it on while
pressing and holding down the
NU/CU ENT key.
Turning off the power
Press the POWER key.
The next time you turn on the power the unit
starts up with the last-used display mode.
Meaning
GPS 2D
GPS 3D
Differential 2D
Differential 3D
WAAS 2D
WAAS 3D