Furuno DUAL GPS GP-150-DUAL Operator's Manual page 55

GPS position smoothing
1) Press MENU ESC, 9 and 6.
2) Press or to select Posn.
3) Enter smoothing factor in three digits
(0000-9999).
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
GPS speed smoothing
1) Press MENU ESC, 9 and 6.
2) Press or to select Spd.
3) Enter smoothing factor in three digits
(0000-9999).
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
Speed averaging
1) Press MENU ESC, 9 and 6.
2) Press to select Speed Average.
3) Enter smoothing factor in two digits
(0000-9999).
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
RAIM function
1) Press MENU ESC, 9 and 6.
2) Press to select RAIM Function on
page 2/2.
GPS SETUP
To Previous Page
RAIM Function Off
RAIM Accuracy 100 m
Geodetic Datum WGS84 NAD27 Other
(Cannot be changed)
POSN Offset 0.000' N 0.000' E
Time DIFF +00:00
POSN 38˚ 00.000' N 123˚ 00.000' W
: Select
MENU : Escape
Figure 8-2 GPS SETUP menu, page 2/2
3) Press or to turn RAIM Function On
or Off as appropriate.
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
2/2
On
(001)
ENT : Enter
: +/
RAIM accuracy
1) Press MENU ESC, 9 and 6.
2) Press or to select RAIM Accuracy
on page 2/2.
3) Key in the range for which you want to
know RAIM accuracy (1 to 999 m).
Note: Unit is meter only.
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
Geodetic datum
1) Press MENU ESC, 9 and 6.
2) Press or to select Geodetic
Datum on page 2/2.
3) Press or to select geodetic datum
to use. For geodetic datum other than
WGS-84 or NAD-27, select Other and
key in chart number (001-173) referring
to the geodetic chart list in the Appendix.
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
Position offset
If you do not know the type of chart you are
using, GPS position may be wrong. Note the
difference in position when moored to a pier
and enter it on the GPS SETUP menu, to get
correct position.
1) Press MENU ESC, 9 and 6.
2) Press or to select POSN Offset on
page 2/2.
3) If necessary press
north latitude to south latitude or vice
versa.
4) Key in latitude correction.
5) If necessary press
east longitude to west longitude or vice
versa.
6) Key in longitude correction.
7) Press the NU/CU ENT key.
8) Press the MENU ESC key.
The L
icon appears when L/L offset is
L
applied.
8. MENU SETTINGS
to switch from
to switch from
8-3