Transmitting Data - Furuno DUAL GPS GP-150-DUAL Operator's Manual

1. OPERATIONAL OVERVIEW
Data display
Refer to Chapter 6 for user-defined window
setting. The ZOOM icon can be displayed by
pressing the CURSOR ON/OFF key.
Position in latitude and
longitude or LOPs
Fixing date and time*
SEP 12, 2009 23:59'59" U
12˚ 23.456' N
Position
123˚ 23.456' E
W84
RNG BRG
223.4˚
31.23
NM
SOG COG
12.3
123.4˚
kn
User-defined
User-defined
display data #1
display data #4
User-defined
display data #2
User-defined
display window
Figure 1-11 Data display mode
*: "--" appears until position is found. If fixing
error occurs the time indication freezes.
1.5

Transmitting Data

The GPS navigators share the data listed
below when transmitting data to each other.
Any action initiated against those data is
automatically repeated on the other navigator.
For example, if you register waypoint 27 on
one navigator it will be registered on the other
navigator under the same waypoint number.
• Alarm settings, alarm buzzer
• Destination data
• Disabled satellite data
• MOB/Event mark data
• Route data
• Waypoint data
Note: This operation is necessary after
receiving waypoint data through the
DATA 4 port (Page 10-14).
1-6
U: UTC
J: JST
Zoom icon S: Ship's time
D3D 100m
* SAFE
TO : 001
MARINE
POINT1
: 002
NEXT
MARINE
POINT2
Next destination waypoint
Current destination waypoint
User-defined
display data #3
Transmitting data
To mutually transmit data, do the following:
1) Press the MENU ESC key to display the
MAIN menu.
MAIN MENU
1. DISPLAY SETUP
2. TRACK/MARK SETUP
3. ERASE TRACK/MARK
4. ALARM SETTINGS
5. MANUAL CALCULATION
6.
7. GPS MONITOR
8. SELF TESTS
9. SYSTEM SETTINGS
ENT: Enter
Figure 1-12 MAIN menu
2) Press the 9 key to display the SYSTEM
SETTINGS menu.
SYSTEM SETTINGS
1. PLOTTER SETUP
2. UNIT SETUP
3. DATA 1, 3 OUTPUT SETUP
4. DATA TRANSFER
5. DATA 4 I/O SETUP
6. GPS SETUP
7. WAAS/DGPS SETUP
8. LOP SETUP
9. CLEAR MEMORY
ENT: Enter
Figure 1-13 SYSTEM SETTINGS menu
3) Press the 4 key to select DATA
TRANSFER.
DATA TRANSFER
Transmit Data
All
: Select
ENT: Enter
Figure 1-14 DATA TRANSFER menu
MENU: Escape
MENU: Escape
Stop Start
MENU: Escape