4-6.
Using the Instrument Setup Menu
Refer to the softkeys in the instrument setup menu (accessed by pressing INSTMT
SETUP softkey in the Setup Menu) shown below.
f
The list below describes submenus accessed by each softkey.
•
OTHER SETUP Opens the Other Setup menu to set the clock and other
miscellaneous parameters.
•
DISPLAY SETUP Opens submenus to set the brightness and contrast of both the
Control Display and Output Display.
•
REMOTE SETUP Allows you to change the configuration of the two RS-232 ports,
SERIAL 1 FROM HOST and SERIAL 2 TO UUT, and IEEE-488 General Purpose
Interface Bus (GPIB). (See Chapter 5 for more information.)
4-7.
Utility Functions Menu
The Setup Menu softkey labeled UTILITY FUNCTNS (Utility Functions) provides
access to Self Test, Format Nonvolatile Memory, and Instrument Configuration.
f
•
SELF TEST This softkey gives access to several calibrator selftests.
•
FORMAT NV MEM (Format Nonvolatile Memory) Opens a menu to restore all or
part of the data in the nonvolatile memory (EEPROM) to factory defaults.
•
INSTMT CONFIG (Instrument Configuration) Allows you to view the versions of
software installed in the calibrator as well as the user-entered report string.
OTHER
SETUP
f
f
SELF
TEST
f
f
DISPLAY
REMOTE
SETUP
SETUP
f
f
FORMAT
INSTMT
NV MEM
CONFIG
f
f
Front Panel Operation
Using the Setup Menu
4
4-5