Configuration (Setup Menu Key); Disk Drive Selection - Fluke 9100A Operation Manual

CONFIGURATION (SETUP MENU KEY)

Configure the system each time you power-up or reset it or
change parts of it. After doing so for one type of UUT, if you
change to another, you should reconfigure the system.
Configuration sets system parameters such as the disk drive to
be used, error reporting, and port configurations.

Disk Drive Selection

Steps 3 through 7 in Section 2, "Operator's Keypad and
Display," showed how to select a disk drive. Selecting a disk
drive is only necessary if your user disk is not in the default
drive. The default drives are:
HDR (hard disk) in the 91OOA.
l
DR2 (drive 2) in the 9105A.
After configuring the system as described in the following
sections, you should verify that the UUT directory is, in fact, on
the user disk in the drive specified by the configuration. To
verify the drive:
1 . Press the SETUP MENU key and use the left arrow
key to move the cursor to the left-most field.
2.
Press the SETUP softkey.
3.
Move the cursor to the next field and press the
4. Verify that the drive specified in the right-most field
contains the user disk with the UUT directory you
need. Possible drives are:
HDR (internal hard disk): 9100A
DR2 (Drive 2): 9105A lower disk drive.
4.3.
4.3.1.
only.