Table of Contents
Advertisement
Introduction
This section of the manual discusses initial installation for the RUSKA 7750i ADTS.
Installing the ADTS involves connecting the supply and test pressure tubing, powering
up the unit, and configuring the system through the front panel.
Unpacking the ADTS
Carefully unpack all components, checking for obvious signs of damage. The shipment
contains the following items:
1. RUSKA 7750i ADTS,
2. Power cord and fittings kit,
3. Users manual,
4. Calibration report,
5. User-specified instrument options.
If necessary, report any shipping damage to the freight agency. Remove all shipping and
packing materials (including the shipping plugs) from all components. If possible, save
the packing materials for future shipping needs.
Finally, install the ADTS in a location that meets the requirements listed in Table 3-1.
The ADTS should be handled in such a way as to minimize mechanical
shocks or vibration during installation or use. It should be mounted on a
rigid bench or in a sturdy 19"-wide rack, (cabinets 18" to 24" deep). An
optional Rack-Mounting Kit is available — Part Number 7250-903.
Although the zeroing process will compensate for a slightly unlevel
mounting, the ADTS should be mounted to within 5° of level.
Note
Chapter 3
Installation
3-1
Advertisement
Table of Contents
