Table of Contents
Advertisement
1. The pressure units are defined from the Menu | Menu| Setup | Units. From the Main Menu
(press PREVIOUS until the Main Menu appears), press Menu [F6], Menu [F6], then Setup
[F2], then Units [F3].
2. Use the rotary knob to highlight the desired user-defined unit, and then select the
Edit Name [F1] function key.
3. The following sequence is used to change the name of the selected unit.
a. Use the < [F4] or > [F5] key to highlight the desired character in the matrix.
b. Use the rotary knob to change the character.
c. Repeat steps a and b until the desired name is entered. Press the Clear key to start over.
d. Press the Done [F6] key when the name change is completed.
4. Use the rotary knob to highlight the desired user-defined unit that has just been renamed.
5. Use the numeric keypad to enter the conversion factor and press ENTER to accept.
6. Press PREVIOUS three times to return to the Main Menu. The new unit definition may now
be selected using the Units key.
Menu | Setup — Remote
The Menu | Setup | Remote screen is where the remote communication interface is set-up.
Figure 4-13. Menu | Menu | Setup | Units | Edit Name
Figure 4-14. Menu | Menu | Setup | Remote
4
Local Operation
Menu
gme20.bmp
gme21.bmp
4-15
Advertisement
Table of Contents
