Table of Contents
Advertisement
Capabilities
The ADTS can be operated remotely by a computer. Two interfaces are supported:
IEEE-488 and RS-232. Both interfaces support SCPI (Standard Commands for
Programmable Instruments). The IEEE-488 interface additionally supports emulation of a
RUSKA 6610 ADTS. The IEEE-488 interface conforms to the following standards:
ANSI/IEEE Std 488.1-1987
ANSI/IEEE Std 488.2-1987
SCPI 1991.0
IEEE-488
The following identification codes define the interface capabilities of the ADTS.
Identification codes are described in the IEEE-488 standard.
SH1
Source Handshake, Complete Capability
AH1
Acceptor Handshake, Complete Capability
T5
Talker
L3
Listener
SR1
Service Request, Complete Capability
RL1
Remote-Local, Complete Capability
PP0
Parallel Poll, No Capability
DC1
Device Clear, Complete Capability
DT0
Device Trigger, No Capability
C0
Controller, No Capability
The IEEE-488 interface is installed next to the processor board. The interface is
identified by the IEEE-488 standard connector on the back panel of the unit.
Do not change any jumpers or switch settings on the IEEE-488 interface
board. The IEEE-488 address is set by the MENU / SETUP / REMOTE
screen.
Remote Operation
IEEE Standard Digital Interface for Programmable
Instrumentation
IEEE Standard Codes, Formats, Protocols, and Common
Commands
Standard Commands for Programmable Instruments
Note
Chapter 5
5-1
Advertisement
Table of Contents
