Table of Contents
Advertisement
BUMPER LIGHT ADJUSTMENT
The low beam can be adjusted slightly
upward or downward. To adjust the
bumper headlight, do the following:
1. Loosen the Phillips® screw located
at the rear of the headlamp.
2. Tilt the headlamp upward or
downward.
3. Tighten the screw.
HEADLIGHT HOUSING REPLACEMENT
To replace the headlight housing, do the following:
1. Remove the two headlight pod screws.
2. Pull the pod cover forward.
3. Unplug the headlamp from the wiring harness.
4. Use a small screwdriver to remove the o-rings from the headlight mounting
tabs.
5. Pull the headlight housing up from bracket for removal.
6. Reverse the steps to install the new housing and reassemble the pod.
MAINTENANCE
147
Advertisement
Table of Contents
