Face Installation - Travis Industries Medium Flush Wood Hybrid Fyre Insert Manual

14 Fireplace Insert Installation
Surround Panel Installation
1. Before installing, the insert should be in place with the flue attached. Attach the brackets as
shown below, using the screws included in the hardware pack with the insert. Make sure the
brackets are flush with the front of the convection chamber.
2. Attach the surround panel as shown below.
HINT: When installing the panel, route the wires through the notch on the bottom of the panel (either side).

Face Installation

There are several face options available for this fireplace insert. Refer to the instructions included with
your face.
© Travis Industries
Small (96100212)
Large (96100215)
4/27/2021 - 1496
(for qualified installers only)
Height Width
30-1/2" 42"
34" 44"
Med Flush Wood Insert