Table of Contents
Advertisement
Quick Links
WARNING: If the information in this manual is not followed exactly, an
uncontrolled fire may result, causing property damage, personal
injury or loss of life.
www.MaverickFirepit.com
Copyright 2011, T.I. Part # 100‐01265_000
$10.00
Maverick
Owner's Manual
WARNING: For Outdoor Use Only
Educate children and adults of the dangers
of the firepit.
Children should be supervised when in the
same area as the firepit.
Do not let children play with the firepit.
Keep pets away from the firepit.
4800 Harbour Pointe Blvd. SW
TM
Firepit
Mukilteo, WA 98275
Advertisement
Table of Contents
Related Manuals for Travis Industries Maverick
Summary of Contents for Travis Industries Maverick
- Page 1 Maverick Firepit Owner’s Manual WARNING: For Outdoor Use Only WARNING: If the information in this manual is not followed exactly, an uncontrolled fire may result, causing property damage, personal injury or loss of life. Educate children and adults of the dangers of the firepit.
-
Page 2: Overview
Important Information No other Maverick Firepit has the same serial number as Register your warranty online at: yours. The serial number is on the listing label that is chained to the firepit. This serial number may be needed www.traviswarranty.com in case you require service. Or, mail your warranty card to: Model: Maverick Firepit Travis Industries House of Fire Serial Number: 4800 Harbour Pointe Blvd. SW Purchase Date: Mukilteo, WA 98275 Purchased From: Save Your Bill of Sale. To receive full warranty coverage, you will need to show evidence of the date you purchased your heater. Do not mail your Bill of Sale to us. We suggest that you attach your Bill of Sale to this page so that you will have all the information you ... -
Page 3: Table Of Contents
Three-Foot Model .......... 5 Touching up the Paint ........11 5 Packing List 12 Replacement Parts 6 Installation Warnings 12 Troubleshooting Consult Local Regulations ......6 © Travis Industries, Inc. 4110603 100-01265_000... - Page 4 (25 ft., or 7.6 m) occur if the above are not followed exactly. of this firepit. Travis Industries, Inc. grants no warranty, The surfaces of this outdoor firepit are hot when in implied or stated, for the installation or use.
-
Page 5: Firepit Dimensions
Height – 12.5 inches (318mm) Figure 1: Five‐Foot Model Three-Foot Model Diameter – 62 inches (1576mm) Radius from center to Inner Ring – 18 inches (458mm) Radius from center to outside of Outer Ring – 30 inches (762mm) Inner dimension – 3 feet (915mm) Outer dimension – 5 feet (1525mm) Height – 12 inches (306mm) Figure 2: Three‐Foot Model Packing List Firepit: (4) decorative covers (4) sections (8) bolts (16) washers (8) nuts NOTE: The nuts and bolts attaching the firepit to the pallet are used for installation. Do not throw these away after detaching the firepit from the pallet. © Travis Industries, Inc. 4110603 100-01265_000... -
Page 6: Installation Warnings
Consult your local city or county regulations for firepits before proceeding with installation. Local regulations govern building and using firepits on private and public property. Some cities and regions require a burning permit before starting an outdoor fire, and seasonal or time of day restrictions. Some firepit regulations dictate the type of materials out of which it should be constructed. Laws may also govern what can be burned in a firepit or how ashes are disposed. Placement Requirements For Outdoor Use Only. Install only in well-ventilated areas. Do not locate the firepit: In high traffic areas Under or near trees, plants and buildings where debris may constantly fall into the firepit. Excessive debris will require high maintenance and/or cause malfunctioning of the firepit. In places where people, children, and pets may contact the firepit. Guards or fences around the firepit in these locations are recommended. Clearances: NOTE: All clearances are measured from the outside edge of the firepit. The distance from any structure or combustible material to the firepit perimeter shall be a minimum of 25 ft. (7.62 M). Lesser clearances shall be used only where acceptable to the local authority having jurisdiction. The distance from any overhanging foliage (trees, shrubs, and so on) to the firepit shall be a minimum of 15 feet (4.572 M). © Travis Industries, Inc. 4110603 100-01265_000... - Page 7 Installation (for qualified installers only) 15’ (4.57M) 25’ (7.62M) Gravel Soil Soil 3” (76mm) Non-combustible material for drainage Figure 3: Clearances NOTE: Heat from the firepit may adversely affect nearby foliage. © Travis Industries, Inc. 4110603 100-01265_000...
-
Page 8: Before You Begin
Precautions" on page 13. Failure to follow the instructions may result in property damage, bodily injury, or death. NOTE: The sections of the firepit are heavy, and may require two people to lift them into place. Tools Needed Two ¾” wrenches Installation Instructions NOTE: The nuts, bolts, and washers attaching the firepit to the pallet are used for installation. Do not throw these away after detaching the firepit from the pallet. NOTE: The 3‐foot model is shipped in 2 halves, 2 sections per half. You may want to loosen the bolts before assembling, to ensure correct alignment. 1. Determine the location of the firepit. Make sure all clearances are met (see page 6). 2. Prepare the firepit location. We recommend 3” (77mm) of compacted sand or gravel under the firepit, extending 12” (305mm) beyond the outside edge. 3. Place section 1 as shown in Figure 5; place section 2 as shown in Figure 6. The pipe at the right of each section fits into the hole at the left of the next section, so that the holes in the brackets align. NOTE: Each section of the firepit is numbered and must be assembled sequentially to ensure proper alignment. You can identify each section by the number of tack welds inside the corner box (see Figure 4). Section 1 has 1 tack weld; section 2 has 2 tack welds, and so on. NOTE: Do not bolt the sections together yet. Figure 4: Location of Tack Weld Figure 5: 1st Section Figure 6: 1st and 2nd Sections Assembled © Travis Industries, Inc. 4110603 100-01265_000... - Page 9 Installation (for qualified installers only) 4. Place sections 3 and 4 as shown below. Figure 7: Three Sections Assembled Figure 8: All 4 Sections Assembled 5. Attach the sections, installing the bolts, washers, and nuts in each section, but do not tighten yet. There are top and bottom bolts for each section. See the photos below. Figure 9: Attaching Sections Figure 10: Attached Section With Loose Bolts 6. Tighten each bolt with the wrenches in several turns, alternating the bolts. This will help align the firepit. Figure 11: ¾” Crescent and Ratchet Wrenches Figure 12: Tightening the Bolts © Travis Industries, Inc. 4110603 100-01265_000...
- Page 10 Installation (for qualified installers only) When tightened, the insides of each bracket section should be flush with each, as shown in the photos below. Figure 13: Bottom of Section Is Flush Figure 14: Top and Bottom of Sections Are Flush 7. Attach the 4 decorative bracket covers to the locations provided, starting at the bottom of each section, as shown below. Figure 15: Attaching the Decorative Cover Figure 16: Decorative Cover Attached The completed firepit assembly should look like that in the photo below. Figure 17: Completed Firepit Assembly © Travis Industries, Inc. 4110603 100-01265_000...
-
Page 11: Operating Instructions
Failure to inspect and maintain may lead to malfunctioning of the firepit and potentially dangerous situations. Your Maverick Firepit is designed to be cleaned and maintained easily. Inspect the firepit before each use. Keep the firepit clean, and remove any debris that collects in or on the firepit. The firepit will develop surface rust and discoloration over time – this is normal. Winterizing the Firepit In areas where the firepit may not be used in winter, or for an extended period of time, you may wish to cover the firepit. After a period of storage and/or non‐use, check for signs of damage and creosote build‐up. Do not operate until necessary repairs and/or cleanup are executed. Touching up the Paint This firepit may be re‐painted using Stove‐Bright metallic black paint available from your dealer. © Travis Industries, Inc. 4110603 100-01265_000... -
Page 12: Replacement Parts
Operation & Maintenance Replacement Parts Part # Description Diagram # Replacement parts can be obtained from your Maverick Firepit retailer (see www.maverickfirepit.com). Troubleshooting Problem: Possible Cause: Don't Call for Service Until You: © Travis Industries, Inc. 4110603 100-01265_000... - Page 13 IF WARRANTY SERVICE IS NEEDED: 1. If you discover a problem that you believe is covered by this warranty, you MUST REPORT it to your TRAVIS dealer WITHIN 30 DAYS, giving them proof of purchase, the purchase date, and the model name and serial number.
- Page 14 Before You Begin ........ 8 Packing List .......... 5 Dimensions .......... 5 Placement Requirements ...... 6 Important Registration and Recommended Order of Service Information ...... 2 Installation ........... 8 Installation Warnings ...... 6 Replacement Parts ......... 1 3 Maintaining Your Firepit ....... 12 Troubleshooting ........ 1 3 Operating Instructions ...... 12 Winterizing the Firepit ...... 1 2 Overview .......... 2 © Travis Industries, Inc. 4110603 100-01265_000...