RSV4 RR-RF
•
Block the rotation with a hex wrench on
the threaded pin (1); Unscrew and re-
move the DAX nut (2)
•
Repeat the operation to remove all
nuts and corresponding pins.
•
Remove the sprocket (3) and the
flange (4)
FITTING
•
Fit the sprocket (3) and the flange (4)
on the crown gear
•
Place the pins (1) with the corresponding DAX nuts (2) paying attention so the pins are
directed towards the inside the machining on the flange
CAUTION
WITH EVERY REMOVAL, REPLACE THE PINS AND NUTS WITH THE NEW COMPONENTS
Suspensions
SUSP - 425