APRILIA RSV4 RR 2017 Service Station Manual page 179

RSV4 RR-RF
•
The injection relay (No. 33 in the electrical circuit diagram, placed under saddle, right side;
CHECK, however, the identification of the relay with the colour of the cables) is energised
for 5 seconds and the injector cable connected to control unit is closed to ground for 4 ms
per second. Disconnect the 4-way connector of the fuel pump to be able to hear the relay
and injector activation. Electrical continuity is required in the wiring for the relay to activate
correctly: no errors are generated if the relay fails to activate
Upper injector cylinder 4
•
The injection relay (No. 33 in the electrical circuit diagram, placed under saddle, right side;
CHECK, however, the identification of the relay with the colour of the cables) is energised
for 5 seconds and the injector cable connected to control unit is closed to ground for 4 ms
per second. Disconnect the 4-way connector of the fuel pump to be able to hear the relay
and injector activation. Electrical continuity is required in the wiring for the relay to activate
correctly: no errors are generated if the relay fails to activate
DIAGNOSTIC TOOL: ELECTRICAL ERRORS
Rear bank upper injector cylinder P0205
•
short circuit to positive / short circuit to negative / open circuit
Error cause
•
Short-circuit to positive: excessive voltage has been detected on VEHICLE PIN 53. If short
circuit to negative: no voltage has been detected. If open circuit: an interruption has been
detected
Troubleshooting
•
Short-circuit to positive: disconnect the injector connector, set key to ON, activate the com-
ponent with the diagnostic tool and check the voltage on the orange/red cable on the injector
connector (if present): if there is voltage, restore the filter box cable harness. If there is no
voltage, replace the sensor
•
If short circuit to negative: disconnect the injector connector, set the key to ON and check if
there is a ground connection on the orange/red cable: if the connection is present, restore
the cable harness. If there is no connection, replace the injector
•
If open circuit: check the component correct electrical characteristic: if it is not the correct
one, replace the component; if it is correct, check the connector on the component and the
Marelli control unit connector: if not OK, restore. If OK, check cable continuity between VE-
HICLE PIN 53 and component PIN - and restore the cable harness
Front bank upper injector cylinder 2 P0206
•
short circuit to positive / short circuit to negative / open circuit
Error cause
Electrical system
ELE SYS - 179