APRILIA RSV4 RR 2017 Service Station Manual page 170

Table of Contents

Advertisement

Electrical system
read by the control unit, but a recovery value is
displayed
Lambda correction
Example value with key ON: 0 %
Example value with engine on: -10% /
+10%
In closed loop, the value must be close to 1.00
(values not within the - -15% / +15% interval indi-
cate a fault). In an open circuit, the lambda probe
signal is too low. Therefore, the control unit takes
it as a lean mixture condition and will try to enrich
it. The value read will be +25%: once this value is
reached and remains unchanged for a certain
time, the lambda probe functional diagnosis is ac-
tivated, resulting in it being deactivated.
This diagnosis is activated when the correction
constantly arrives -25%.
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING,
CAREFULLY READ THE GENERAL TROUBLESHOOTING
CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGIN-
NING OF THE CHECK AND CONTROL SECTION IN THE
ELECTRICAL SYSTEM CHAPTER.
DIAGNOSTIC TOOL: STATUSES
Lambda probe: Start-up_Lean_Rich_Fault due to rich titre_Fault due to lean air-fuel mixture
If the probe connector is disconnected (voltage almost equal to zero) it switches to the state
of Fault due to lean air-fuel mixture
Lambda check: Open loop/Closed loop/Rich in closed loop/Lean in closed loop/enriched
Closed loop indicates that the control unit is using the lambda probe signal to keep the
combustion is close as possible to the stoichiometric value.
DIAGNOSTIC TOOL: ACTIVATIONS
Lambda probe heater
The injection relay (No. 33 in the electrical circuit diagram, placed under the saddle next to
the battery positive, CHECK, however, the identification of the relay with the colour of the
cables) is energised and the heating circuit is closed to ground 5 times (pin 3 of the Lambda
probe connector). Electrical continuity is required in the wiring for the relay to activate cor-
rectly: no errors are generated in case of no activation.
DIAGNOSTIC TOOL: ELECTRICAL ERRORS
P0130 Front bank lambda probe
Electrical diagnosis:
ELE SYS - 170
RSV4 RR-RF

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rsv4 rf 2017

Table of Contents