Push Handles/Push Bars; Height Adjustment Push Handles/Push Bars - Invacare rea Azalea Assist User Manual

Rea® Azalea®

3.8 Push handles/Push bars

The following instructions and warnings are valid for all push
handles and the push bar:

3.8.1 Height adjustment push handles/push bars

Adjusting the height of the connected push
handles
1. Loosen the hand wheels B.
2. The height of the push handles braced / push bar A can
be adjusted simply by pulling the handles upwards or
pushing them downwards.
3. Adjust to the height that you require.
4. Re-tighten the hand wheels.
A
Make sure that the hand wheel for the push handle
A fits the hole in the tubes. If the threaded tap of
the hand wheel B is more than app. 2,5 mm visible,
the position is wrong. Lower or raise the push handle
to get the hand wheel in the correct position.
The push bar/push handles braced A must not be
pulled up so that it protrudes more than 19 cm over
the top edge of the attachment.
14
A
B
B
A
CAUTION!
Risk of trapping fingers
– Do not trap your fingers between the push
handles braced and the neckrest attachment.
(If you have a tension adjustable backrest).
Push bar Azalea Max
B
A
1. Loosen the handwheels. A.
2. The height of the push handles braced / push bar B can
be adjusted simply by pulling the handles upwards or
pushing them downwards.
3. Adjust to the height that you require.
4. Re-tighten the handwheels.
Adjusting the height of the push bar
A
1. Loosen the hand wheels A.
2. Adjust the handles to the required height position.
There are two fixed positions available.
3. Re-tighten the hand wheels.
WARNING!
Risk of injury
The push bar can loosen from the attachments
– Make sure that the marking B on the tubes are
fitted against the backrest tube.
– Check that the handwheels can be tightened
properly, the screw of the handwheel should
barely be visible. If the push bar is in the wrong
position, the handwheel will not be possible to
tighten properly.
B
1488727-R