Van Seat - Invacare Pronto M91 User Manual

Van Seat

For this procedure, refer to FIGURE 11.

Take note of position and orientation of mounting hardware for reinstalling the joystick assembly.
1. Turn the adjustment lock lever to release the joystick mounting tube from the mounting bracket.
2. Remove the joystick from the wheelchair.
3. Remove the three hex mounting screws, spacers and locknuts that secure the mounting bracket to the three mounting holes on the arm frame.

The mounting bracket is mounted to the inside of the arm frame.
4. Reposition the mounting bracket on the opposite arm frame.
5. Using the three hex mounting screws, spacers and locknuts secure the mounting bracket to the three mounting holes of the arm frame.
6. If necessary, perform the following to reposition the adjustment lock:
A. Slide the adjustment lock from the mounting bracket.
B. Rotate adjustment lock 180° and slide adjustment lock over the opposite end of the mounting bracket.
7. Slide joystick mounting tube through the mounting bracket to the desired position and secure adjustment lock to tube by turning lever on
adjustment lock.
 MK5 SPJ-80 joystick shown, all other
joysticks reposition in the same way.
Part No 1143153
Hex Mounting Screws
Adjustment Lock Lever
FIGURE 11 Repositioning Joystick - Van Seat
Mounting Bracket
109
11 SETUP/MAINTENANCE
Locknuts
Arm Frame
Spacers
Joystick Mounting Tube
Invacare® Pronto® M91™