Symantec NetBackup 5020 Routine Maintenance page 39

NetBackup 5020
Routine Maintenance
Parameter
Status
Capacity
Type
Enclosure ID
ErrorStatus
----End
Exception Handling



Issue 01 (2010-12-10)
Description
The operational state of the disk.

Online indicates that the hard disk is configured in a RAID group
and operates normally.
 Hotspare indicates that the disk is hotspare disk.

Rebuild indicates that the disk is being rebuilt.
 Unconfigured(good) indicates that the hard disk is not configured
in a RAID group but operates normally.

Unconfigured(bad) indicates that the hard disk is not configured
in a RAID group and failed.
 Failed indicates that the disk is configured in a RAID group but is
disabled.

Missing indicates that the disk is missing.
 Offline indicates that the member disk in a RAID group is offline.
The disk capacity. Unit: TB.
NOTE
A 2 Terabyte disk has 2x10
The physical type of the disk. The type of disks in the NetBackup
5020 is SATA.
The ID of the enclosure in which the disk is.
The value of Enclosure ID is not limited. The default value is 8.
Hard disk status.
 If the value of ErrorStatus is 0, it indicates that a hard disk is
working normally.

If the value of ErrorStatus is 1, it indicates that a hard disk is
working abnormally.
If a disk is in the Rebuild state, wait until it return to Online state.
If Slot Number of a present disk cannot be found in the interface, refer to "Some Disks
Can Not Be Scanned" in the NetBackup 5020 Hardware Troubleshooting.
If a disk is in the Unconfigured (bad), Failed, Missing, or Offline state, replace this
hard disk. For details about how to replace a hard disk, refer to "Replacing a Hard Disk"
in the NetBackup 5020 Hardware Troubleshooting.
Symantec Corporation
4 Guide to the Routine Maintenance Using the System
12
bytes, this is represented as 1.817 TB.
Monitor Interface
4-9