Checking The Fan Status - Symantec NetBackup 5020 Routine Maintenance

4 Guide to the Routine Maintenance Using the System
Monitor Interface
Parameter
ErrorStatus
----End
Exception Handling
If the RAID group is in the Degraded state, contact the technical support engineers if the
RAID group does not successfully rebuild automatically.

4.5 Checking the Fan Status

This section describes how to check the fan status on the system monitoring interface. By
checking the fan status, you can know whether the fan works normally.
Impact on the System
None.
Reference Standard
The normal state of a fan is Device Present.
Procedure
Step 1 Log in to the system monitoring interface.
For the detailed procedure, see
Step 2 Expand the node in the navigation tree, and then click Fan, as shown in
4-12
Description
RAID group status.

If the value of ErrorStatus is 0, it indicates that a RAID group is
working normally.
 If the value of ErrorStatus is 1, it indicates that a RAID group is
working abnormally.
Log into the system monitoring
Symantec Corporation
NetBackup 5020
Routine Maintenance
interface.
Figure 4-12.
Issue 01 (2010-12-10)