Viewing The Disk Status; Table 4-2 Description Of Parameters Related To The Cpu Status - Symantec NetBackup 5020 Routine Maintenance

NetBackup 5020
Routine Maintenance

Table 4-2 Description of parameters related to the CPU status

Parameter
Status
Voltage
LowWaterMark
HighWaterMark
ErrorStatus
----End
Exception Handling
If the CPU is in the Failure detected state, contact the technical support engineers.

4.3 Viewing the Disk Status

This section describes how to check the disk status on the system monitoring interface. By
checking the disk status, you can know whether the disk works normally.
Impact on the System
None.
Reference Standard



Procedure
Step 1 Log in to the system monitoring interface.
For the detailed procedure, see
Step 2 Expand the node in the navigation tree, and then click Disk, as shown in
Issue 01 (2010-12-10)
Description
The state of the CPU.
 Presence detected indicates that the CPU is working normally.

Failure detected indicates that the CPU is absent.
The voltage of the CPU.
The Voltage value ranges between LowWaterMark and
HighWaterMark, that is, between 0.530 Volts and 1.760 Volts.
Lowest value of the CPU voltage. The value is 0.530 Volts.
Highest value of the CPU voltage. The value is 1.760 Volts.
CPU status.
 If the value of ErrorStatus is 0, it indicates that a CPU is working
normally.

If the value of ErrorStatus is 1, it indicates that a CPU is working
abnormally.
The normal state of a system disk is Online.
The normal state of a data disk is Online or Unconfigured(good).
The normal state of a hot spare disk is Hotspare.
Symantec Corporation
4 Guide to the Routine Maintenance Using the System
Log into the system monitoring
Monitor Interface
interface.
Figure 4-8.
4-7