Bosch VideoJet 8008 Installation And Operating Manual page 85

VideoJet 8008 | Installation and Operating Manual
Alarm connections
You can select the response of the VideoJet 8008 in case of an alarm. In case of
an alarm, the VideoJet 8008 can automatically establish a connection to a
predefined IP address. You can enter up to ten IP addresses which will be
selected in order by the unit in case of an alarm until a connection is established.
You can also choose which camera image should automatically be displayed
first on the receiver in case of an alarm.
Connect on alarm:
Select On so that the VideoJet 8008 automatically establishes a connection to
one of the pre-defined IP addresses in the event of an alarm.
Note
For alarm connections, always Stream 2 is transmitted. Take this into
account when assigning the profile (see page 66).
Number of destination IP address:
Here you assign the numbering for the IP addresses to be contacted in the event
of an alarm. The unit contacts the remote locations one after the other in the
numbered sequence until a connection has been established.
Destination IP address:
For each number, enter the corresponding IP address for the desired remote
location.
Destination password:
If the remote location is password protected, enter the password here.
Bosch Security Systems | 2005-06 | V2.0
EN | 85
Configuration using a Web Browser