Bosch VideoJet 8008 Installation And Operating Manual page 24

EN | 24
Command entry
After the connection has been established, you must log on to the
VideoJet 8008. You can then access the main menu. You can call up additional
submenus and functions using the on-screen commands.
– If necessary, turn off the local echo so that entered values are not repeated
on the display.
– Enter only one command at a time.
– After entering a value (such as an IP address), re-check the entry before
pressing the ENTER key to transfer the values to the VideoJet 8008.
Assigning an IP address
To operate the VideoJet 8008 in your network, a valid IP address for the network
must be assigned.
The following default address has been pre-set at the factory: 192.168.0.1
– Start up a terminal program such as HyperTerminal.
– First enter ? and then service as the user name. The main menu will be
displayed.
– Enter the command i to open the IP menu.
– Enter i again. The current IP address will be displayed, and you will be
requested to enter a new IP address.
Installation
Installation and Operating Manual | VideoJet 8008
Bosch Security Systems | 2005-06 | V2.0