Connections - Bosch VideoJet 8008 Installation And Operating Manual

EN | 20

Connections

Cameras
Up to eight standard video sources (e.g. CCTV cameras) can be connected to
the VideoJet 8008. Any cameras or other video sources that produce a standard
PAL or NTSC signal are suitable.
– Connect each of the cameras or other video sources with a video cable
(75 ohm) to the BNC jacks Video 1 to Video 8.
– Set the slider switch (75 Ω) below the BNC jacks to
input if the signal is not forwarded.
Data interface
The bi-directional data interface is used to control devices connected to the
VideoJet 8008, such as a dome camera with a motorized lens.
The RS232/485 connection supports the RS232, RS422 and RS485
transmission standards.
The serial interface is an RJ45 jack. Information about the pin assignment can
be found on page 124.
The range of controllable devices is growing constantly. The manufacturers of
this equipment can provide specific information on installation and control.
Warning!
Refer to the device documentation when installing and operating a device
to be controlled. This contains important safety instructions and
information about permitted uses.
Note
A video connection is necessary to transmit transparent data.
Network
You can connect the VideoJet 8008 to a 10/100/1000 Base-T network. Use a
standard UTP Category 5 cable with RJ45 connectors for this.
– Connect the unit to the network using the 10/100/1000 Base-T jack.
Installation
Installation and Operating Manual | VideoJet 8008
to terminate the video
Bosch Security Systems | 2005-06 | V2.0