Bosch VideoJet 8008 Installation And Operating Manual page 52

EN | 52
Network settings
Here, you can specify network addresses and configure multiple connections.
Network
The settings on this page are used to integrate the unit into an existing network.
Warning!
Changes to the IP address, subnet mask or gateway address are
transferred to the unit by clicking Set. However, they only take effect after
the unit is restarted.
– Click Set after entering a new IP address.
– To do this, enter the old IP address followed by /reset (for instance
192.168.0.80/reset) in the address bar of your web browser. The
VideoJet 8008 will be restarted, after which it can only be accessed at the
new IP address.
IP address:
Enter the desired IP address for the VideoJet 8008 in this field. The IP address
must be valid for the network.
Subnet mask:
Enter the appropriate subnet mask for the set IP address here.
Configuration using a Web Browser
Installation and Operating Manual | VideoJet 8008
Bosch Security Systems | 2005-06 | V2.0