Bosch VideoJet 8008 Installation And Operating Manual page 114

EN | 114
Connecting with a terminal program
Various requirements must be met in order to operate using a terminal program
(see page 23).
– Start the terminal program and enter the command i in the main menu to
switch to the IP menu.
– Enter the command r in the IP menu to change the remote IP address, then
enter the IP address of the device to connect to.
– Enter the command a in the IP menu to activate the automatic connection set
up.
Connecting with a web browser
Various requirements must be met in order to operate using a Web program
(see page 27).
Note
Transmitter and receiver must be located in the same subnet to establish
a hardware connection with a web browser (see pages 52 and 89).
– Use the web browser to connect to the receiver. Its home page will be
displayed.
– Under Video sources on the page CONNECTIONS, select the
VideoJet 8008. A JPEG snapshot of the video source selected will be
displayed on the page.
– Set the video input you want the images to come from.
– Click MPEG-4 connection to begin displaying the video images on the
connected monitor.
Operation
Installation and Operating Manual | VideoJet 8008
Bosch Security Systems | 2005-06 | V2.0