Bosch VideoJet 8008 Installation And Operating Manual page 51

VideoJet 8008 | Installation and Operating Manual
Destination IP address:
For each number, enter the corresponding IP address for the desired remote
location.
Destination password:
If the remote location is password protected, enter the password here.
Auto-connect:
Select On if an active connection should be re-established automatically to one
of the previously specified IP addresses after each restart, connection
breakdown or network failure.
Note
For automatic connections, always Stream 2 is transmitted. Take this into
account when assigning the profile (see page 32).
Default camera:
Here you can select the camera whose image will automatically be displayed
first to the receiver after the alarm connection has been established. Depending
on the system configuration, the receiver can then also select the other
cameras.
Note
The numbering corresponds to the labeling of the video inputs on the rear
panel of the unit.
Bosch Security Systems | 2005-06 | V2.0
EN | 51
Configuration using a Web Browser