The Stp Port Edit Screen - ZyXEL Communications GS1900 Series User Manual

The following table describes the labels in this screen.
Table 117 Configuration > Spanning Tree > STP Port
L ABEL
STP Port
Port
State
External Cost
Edge Port
BPDU Filter
P2P MAC
Edit
Cancel
27.2.3 T he ST P Po rt Edit Sc re e n
Use this screen to configure the
to open this screen.
Fig ure 171
The following table describes the labels in this screen.
Table 118 Configuration > Spanning Tree > STP Port > Edit
L ABEL
STP Port
Port List
External Path
Cost (0=Auto)
State
Edge Port
BPDU Filter
Chapter 27 Configuration: Spanning Tree
DESC RIPT IO N
Displays the index number of the STP port.
Display the status of the STP port as enabled or disabled.
Displays the external path cost.
Displays the edge port status as
Displays the BPDU filter status as
Displays the P2P MAC status as
Select this check box to configure the properties of a port. Click the
properties of the port.
Click to discard the changes.
C a nc e l
ST P Po rt Edit
Configuration > Spanning Tree > STP Port > Edit
DESC RIPT IO N
Enter the index number of the STP ports.
Enter the external path cost. Enter
Select the state of the STP port as enabled or disabled.
Select this check box to configure a port as an edge port when it is directly attached to a
computer. An edge port changes its initial STP port state from blocking state to forwarding state
immediately without going through listening and learning states right after the port is configured
as an edge port or when its link status changes.
Note: An edge port becomes a non-edge port as soon as it receives a
Bridge Protocol Data Unit (BPDU).
Select to activate BPDU filter or
Ye s
GS1900 Series User's Guide
or .
Ye s No
or .
Ye s No
or .
Ye s No
settings. Click
C o nfig ura tio n
for Auto.
0
to deactivate it.
No
171
button change the
Edit
> >
Spa nning T re e ST P Po rt
>
Edit