The Lag Management Screen - ZyXEL Communications GS1900 Series User Manual

Fig ure 144
The following table describes the labels in this screen.
Table 91 Configuration > Link Aggregation > Global
L ABEL
Global
LACP State
LACP System
Priority
Load Balance
Algorithm
Apply
Cancel
22.2.2 T he L AG Ma na g e m e nt Sc re e n
Use this screen to view LAG management settings. Click
Ma na g e m e nt
Fig ure 145
The following table describes the labels in this screen.
Table 92 Configuration > Link Aggregation > LAG Management
L ABEL
LAG Management
LAG
Name
Chapter 22 Configuration: Link Aggregation
Configuration > Link Aggregation > Global
DESC RIPT IO N
Select to activate the link aggregation control protocol.
Ena b le
LACP system priority is a number between 1 and 65,535. The switch with the lowest system
priority (and lowest port number if system priority is the same) becomes the LACP "server". The
LACP "server" controls the operation of LACP setup. Enter a number to set the priority of an
active port using Link Aggregation Control Protocol (LACP). The smaller the number, the higher
the priority level.
Select the outgoing traffic distribution type. Packets from the same source and/or to the same
destination are sent over the same link within the trunk. By default, the Switch uses the
distribution type. If the Switch is behind a router, the packet's destination or source
Addre ss
MAC address will be changed. In this case, set the Switch to distribute traffic based on its IP
address to make sure port trunking can work properly.
Select
MAC Addre ss
destination MAC addresses.
Select
IP/ MAC Addre ss
destination IP addresses.
Click to save the changes.
Apply
Click to discard the changes.
C a nc e l
to open this screen.
Configuration > Link Aggregation > LAG Management
DESC RIPT IO N
Displays the link aggregation group (LAG), that is, one logical link containing multiple ports.
Displays the name of the link aggregation group.
GS1900 Series User's Guide
to distribute traffic based on a combination of the packet's source and
to distribute traffic based on a combination of the packet's source and
C o nfig ura tio n
145
> >
L ink Ag g re g a tio n L AG
IP/ MAC