The Vlan Screen - ZyXEL Communications GS1900 Series User Manual

Table 107 Configuration > Multicast > IGMP > Global (continued)
L ABEL
Unknown
Multicast Action
Apply
Cancel
26.2.2 T he VL AN Sc re e n
Use this screen to view the
this screen.
Fig ure 161
The following table describes the labels in this screen.
Table 108 Configuration > Multicast > IGMP > VLAN
L ABEL
IGMP Vlan
VLAN ID
State
Router Ports Auto
Learn
Query
Retry
Interval
Max. Response
Interval (sec)
Last Member Query
Count
Interval
Querier
State
Version
Edit
Chapter 26 Configuration: Multicast
DESC RIPT IO N
Select to send the IPv4 unknown multicast frame to the router port. The following options are
available:
• – select to send the frames to all ports.
Flo o d
• – select to discard the frames.
Dro p
• – select to send the frame to router port.
Ro ute r Po rt
Click to save the changes.
Apply
Click to discard the changes.
C a nc e l
IG MP VL AN
Configuration > Multicast > IGMP > VLAN
DESC RIPT IO N
Displays the ID of a static VLAN; the valid range is between 1 and 4094.
Display the status of the VLAN as enabled or disabled.
Displays the Switch learn multicast router port member status of any VLANs as enabled or
disabled.
Displays the number of query retry times.
Displays the amount of time (in seconds) between general query messages sent by the router
connected to the upstream port.
Displays the amount of time (in seconds) the router connected to the upstream port waits for a
response to an IGMP general query message.
Displays the number of queries.
Displays the amount of time (in milliseconds) between the IGMP group-specific queries sent by
an upstream port when an IGMP Done message is received.
Displays the Switch current VLAN querier entry as
Displays the Switch current VLAN querier entry version.
Click to change the properties of the IGMP VLAN entry.
Edit
GS1900 Series User's Guide
settings. Click
C o nfig ura tio n
Ena b le
162
> > >
Multic a st IG MP VL AN
or .
Disa b le
to open