Resetting The Switch (All Models Except Gs1900-24Ep/Gs1900-24Hpv2/Gs1900-48Hpv2) - ZyXEL Communications GS1900 Series User Manual

Table 4 LED Descriptions (continued)(GS1900-8HP (Revision B1) and GS1900-10HP Only)
L ED C O L O R
Left Amber
Green
LED Descriptions for SFP Port (GS1900-10HP Only)
L ED C O L O R
Two arrow LEDs for 1G SFP Slots (Fiber Ports)
right/left arrows Amber
Green
3.4 Re se tting the Switc h (a ll m o de ls e xc e pt G S1900- 24EP/
G S1900- 24HPv2/ G S1900- 48HPv2)
If you lock yourself (and others) from the Switch, or you forget your password, or cannot access the Web
Configurator, you will need to reload the factory-default configuration file. Or use the
the front of the device.
This means that you will lose all configurations that you had previously and the default Switch IP address,
user name and password will be reset to 192.168.1.1, admin and 1234 respectively.
If you backed up an earlier configuration file as advised in
totally re-configure the Switch after resetting. You can simply restore your last configuration.
Follow the steps below to reset the Switch back to factory defaults.
1
Make sure the
the button on the front of the Switch as shown in
RESET
2
Press the button for more than 6 seconds. After releasing the button, the
the Switch to restart (the
Note: If you want to access the Switch Web Configurator again, you may need to change
Chapter 3 Hardware Overview
ST AT US DESC RIPT IO N
On The link to a 10/100 Mbps Ethernet network is up.
Blinking The system is transmitting/receiving to/from a 10/100 Mbps Fiber network.
On The link to a 1 Gbps Ethernet network is up.
Blinking The system is transmitting/receiving to/from 1 Gbps Ethernet network.
ST AT US DESC RIPT IO N
On The link to a 100 Mbps Fiber network is up.
Blinking The system is transmitting/receiving to/from a 100 Mbps Fiber network.
On The link to a 1 Gbps Fiber network is up.
Blinking The system is transmitting/receiving to/from 1 Gbps Fiber network.
LED is steady green (not blinking). Use a pointed instrument such as a pin to access
SYS
LED will be steady green again). This takes up to 2 minutes.
SYS
GS1900 Series User's Guide
Section 1.4 on page
Section 3.1 on page
38
button at
RESET
21, you will not have to
28.
LED begins to blink. Wait for
SYS