ZyXEL Communications GS1900 Series User Manual page 31

7
Identify the signal transmission direction of the fiber cables and the transceiver. Insert the fiber cable into
the transceiver.
Latch in the Lock Position
Fig ure 23
Transceiver Installation Example
Fig ure 24
Connecting the Fiber Cables
Fig ure 25
3.1.2.2 T ra nsc e ive r Re m o va l
Use the following steps to remove an SFP transceiver.
1
Attach an ESD preventive wrist strap to your wrist and to a bare metal surface on the chassis.
2
Remove the fiber cables from the transceiver.
3
Pull out the latch and down to unlock the transceiver (latch styles vary).
Note: Make sure the transceiver's latch is pushed all the way down, so the transceiver can be
pulled out successfully.
4
Pull the latch, or use your thumb and index finger to grasp the tabs on both sides of the transceiver, and
carefully slide it out of the slot.
Note: Do NOT pull the transceiver out by force. You could damage it. If the transceiver will not
slide out, grasp the tabs on both sides of the transceiver with a slight up or down motion
and carefully slide it out of the slot. If unsuccessful, contact Zyxel Support to prevent
damage to your Switch and transceiver.
5
Insert the dust plug into the ports on the transceiver and the cables.
Chapter 3 Hardware Overview
GS1900 Series User's Guide
31