The Port Edit Screen - ZyXEL Communications GS1900 Series User Manual

Table 75 Configuration > VLAN > VLAN > Port (continued)
L ABEL
VLAN Trunk
Edit
Cancel
20.2.4 T he Po rt Edit Sc re e n
Use this screen to configure port settings. Click
screen.
Configuration > VLAN > VLAN > Port > Edit
Fig ure 128
The following table describes the labels in this screen.
Table 76 Configuration > VLAN > VLAN > Port > Edit
L ABEL
Port
Port Select
PVID
Accepted Type
Ingress Filtering
VLAN Trunk
Apply
Cancel
Chapter 20 Configuration: VLAN
DESC RIPT IO N
Enable VLAN Trunking on ports connected to other switches or routers (but not ports directly
connected to end users) to allow frames belonging to unknown VLAN groups to pass through
the Switch.
Select this check box to configure the properties of a port. Click the
properties of the port.
Click to discard the changes.
C a nc e l
DESC RIPT IO N
Displays the list of port index numbers that are being configured.
Enter a number between 1 and 4094 as the port VLAN ID.
Select from the drop-down list box to accept all untagged or tagged frames on this port. This
All
is the default setting.
Select to accept only tagged frames on this port. All untagged frames will be
T a g O nly
dropped.
Select to accept only untagged frames on this port. All tagged frames will be
Unta g O nly
dropped.
If this check box is selected for a port, the Switch discards incoming frames for VLANs that do
not include this port in its member set.
Clear this check box to disable ingress filtering.
Enable VLAN Trunking on ports connected to other switches or routers (but not ports directly
connected to end users) to allow frames belonging to unknown VLAN groups to pass through
the Switch.
Click to save the changes.
Apply
Click to discard the changes.
C a nc e l
GS1900 Series User's Guide
>
C o nfig ura tio n VL AN
131
button change the
Edit
> > > to open this
VL AN Po rt Edit