Table of Contents
Advertisement
Drive Handling and Maintenance
6.1.4
Before removing the drive from its static shielding bag:
Make sure that your work station is properly grounded.
Wear a properly grounded wrist strap with good skin contact.
Avoid contact with any component on the printed circuit board.
After attaching your wrist strap, gently remove the drive from the static shielding bag.
Handle the drive by the sides only; avoid touching the printed circuit board.
Handle the drive with the printed circuit board facing downward during installation.
Do not open the drive's sealed compartment or remove the seals or any labels from the drive; this
will void the warranty.
6.1.5
If you need to move your computer, turn off the power to automatically unload the heads. This helps
protect the media and the heads from accidental damage due to vibration, moving, or shipping.
6.2
Hard Drive Installation
Before you attempt to install this drive, you will need to understand if your system supports a hard
drive larger than 2.19 TB. Visit
2.19 TB capacity barrier.
If your system does not support hot plugging (see "Hot Plug Support" on page 21), it must be turned
off and unplugged before installing your hard drive. This avoids the possibility of reversing the polarity
of the power connections and eliminating current surges that can damage either the drive or computer.
Attach the SATA power supply cable to the SATA device plug power connector (see "Standard Factory
Connectors" on page 12). Both the SATA power and signal connector are keyed to ensure proper
insertion.
Figure 6-1. SATA Cable Connections
44
Removal From Static Shielding Bag
Moving Precautions
http://products.wdc.com/largecapacitydrives
SATA receptacle
interface connector
RELEASED 8/13/13
for more information on the
SATA device plug
interface connector
SATA device plug
power connector
SATA receptacle
power connector
2679-771339-A05
EX800M
Advertisement
Table of Contents
