Table of Contents
Advertisement
5
Raise the vehicle until the tire is slightly raised
off the ground.
WARNING
Observe the following precautions when using the jack.
●
Do not put any part of your body under the vehicle while it is supported by the
jack.
●
Do not start the engine or drive the vehicle while the vehicle is supported by the
jack.
●
Do not raise the vehicle while someone is inside.
When raising the vehicle, do not put an object on or under the jack.
●
●
Do not raise the vehicle to a height greater than that required to replace the tire.
●
Use a jack stand if it is necessary to get under the vehicle.
6
Remove the uppermost wheel bolt and install
the guide pin
Turn the guide pin clockwise to tighten it until it
stops.
WARNING
When removing or installing a tire, make sure to use the guide pin.
Also, the guide pin is made of resin. It may be damaged if the wheel is placed
anywhere other than
by hand.
or if a large amount of force is applied to the guide pin.
9-4. If a tire is flat
615
9
Advertisement
Table of Contents
