6-2. Using the safe driving support functions
Buzzer: Short beep
●
■
Brake control is operating
The system determined that emergency braking is necessary.
●
Multi-information display and head-up display
●
Center display: "BRAKE!"
●
Driving assist infomation indicator: Not illuminated
●
Buzzer: Short beep
●
Vehicle stopped by system operation
■
The vehicle has been stopped by brake control operation.
●
Multi-information display: "Accelerator Pedal is Pressed Press Brake Pedal" (If
●
the accelerator pedal is not depressed, "Press Brake Pedal" will be displayed.)
Head-up display
●
accelerator pedal is not depressed, "Press Brake Pedal" will be displayed.)
Center display: "Press Brake Pedal"
●
Driving assist infomation indicator: Illuminated
●
Buzzer: Sounds repeatedly
●
Static Objects Front and Rear of the vehicle
If the sensors detect a static object, such as a wall, in the travelling direction of the
vehicle and the system determines that a collision may occur due to the vehicle
suddenly moving forward due to an accidental accelerator pedal operation, the
vehicle moving the unintended direction due to the wrong shift position, or while
parking or traveling at low speeds, the system will operate to lessen the impact with
the detected static object and reduce the resulting damage.
INFORMATION
■
The system will operate when
The function will operate when the driving assist infomation indicator is not illuminated or
flashing and all of the following conditions are met:
Engine output restriction control
●
PKSB (Parking Support Brake) system is enabled.
•
•
The vehicle speed is approximately 9 mph (15 km/h) or less.
•
There is a static object in the traveling direction of the vehicle (approximately 6 to
13 ft. [2 to 4 m] ahead).
If equipped
* :
432
*
: "Accelerator Pedal is Pressed Press Brake Pedal" (If the
*
: "BRAKE!"
*