Table of Contents
Advertisement
8-5. Tire maintenance
Before performing ID code registration, make sure that no wheels with tire pres-
sure warning valve and transmitters installed are near the vehicle.
1
Park the vehicle in a safe place, turn the engine switch off and wait 15 minutes
or more.
2
Start the engine.
The ID code registration procedure cannot be performed while the vehicle is moving.
3
Select
on the center display.
4
Select [Vehicle customize].
5
Select [Tire pressure].
6
Check if the desired wheel set ([Set 1] or [Set
2]) is displayed.
ID codes will be registered to the displayed wheel
set.
To change the wheel set to be registered, select
the displayed set, and then select the wheel set
you wish to register.
If ID codes have already been registered for that
wheel set, the tire pressure warning light will slowly blink 3 times, and a message
indicating that change is occurring will be displayed on the multi-information display.
7
Select [New tire registration].
8
Select [Continue].
The tire pressure warning light will slowly blink 3
times and a message indicating that ID code reg-
istration is being performed will be displayed on
the multi-information display. Wheel set changing
will be canceled and registration will begin.
When registration is being performed, the tire
pressure warning light will blink for approximately
1 minute then illuminate and "---" will be displayed for the inflation pressure of each tire
on the multi-information display.
INFORMATION
If the tire pressure warning light does not blink 3 times when starting ID code
registration procedure, the procedure may not have started. Perform the procedure
again from the beginning.
9
Drive straight (with occasional left and right turns) at approximately 25 mph
(40 km/h) or more for approximately 10 to 30 minutes.
540
Advertisement
Table of Contents
