Table of Contents
Advertisement
NOTE - Firmware updates will not affect installer or user thermostat settings. Both
will be retained after the update.
WI-FI SETTINGS
LAWMAC
Wi-Fi
enabled
connected
press to change
press to enable /
network settings
disable Wi-Fi
NOTE -
If any downloads are available for the thermostat they will start downloading
right away. When new firmware is being downloaded or when Gelaskins are
being installed, the thermostat screen will temporarily go blank and running
units may cease operation while the system is being reset to accommodate
Connection to server has not bee established or it has been lost.
the new changes. This is normal and can last a couple minutes.
Please wait until a connection is established.
Figure 30. Registration for Online Access
For any issues with Wi-Fi connections, refer to Wi-Fi Troubleshooting Checklist
507037-01.
ACCOUNT REGISTRATION FOR
Figure 31. iComfort Wi-Fi
NOTE - This following information is customer setup instructions and is
shown here to allow the installer to help walk the customer through the setup
process.
After registering through your iComfort Wi-Fi
homeowners computer and locate the email sent from the server:
Dear Customer,
Congratulations on your purchase of a Lennox iComfort thermostat! You are
only a few steps away from total control of your Lennox iComfort system.
Registering your thermostat will allow you to remotely access it from
anywhere in the world on any device with an Internet connection. Please
complete your Lennox iComfort registration by clicking the link below:
Register
507152-01
Firmware
thermostat
update
registered
auto
press to change
press to toggle
thermostat
off / auto
registration
®
iComfort Wi-Fi
SERVER
®
Registration Screen
®
thermostat interface, go to the
NOTE - if the customer has already setup an account, click the "Click Here"
button to access that account.
Click on the Register link; the screen (to the left) will appear. Fill in the User Name
and Password fields and check the agree to terms and conditions box. Click Create
User button.
A series of pages and prompts follows to provide guidance through profile setup and
user preference definitions.
PC WELCOME PAGE; INTERACTIVE DEMO; ONLINE ICOMFORT
INFORMATION; USING GELASKINS
Figure 32. PC Welcome Screen
Access all the great Wi-Fi enabled features on your iComfort
secure web portal. After signing in, you'll be able to view your iComfort system
settings, adjust the temperature and view reminders and alerts – just as you would
on your iComfort thermostat at home. With a familiar look and settings this simple,
you should feel right at home. Don't forget to check out the available Apps and
customizable skins using the links on the right side of the page. From the welcome
page, you may also click on links to launch an interactive demo or learn more about
iComfort.
HOW DO I TURN ON SKINS ON THE ICOMFORT WI-FI THERMOSTAT?
From the thermostat Home screen, press
saver buttons. From the pop-up menu, select skins. The skin picture will appear
after 30 seconds of inactivity.
HOW DO I UPLOAD A SKIN?
Skins should be ordered from website listed below:
http:// www.gelaskins.com/lennoxicomfort
After ordering the skin, Gelaskins will email the image file (.jpg) to the homeowner.
This "jpg" has been altered to display correctly on the iComfort Wi-Fi Thermostat.
Images can be uploaded to the iComfort Wi-Fi thermostat from the consumer portal
site (www.myicomfort.com) under the tab "skins".
Page 20
®
thermostat from our
then display setting then screen
7/2013
Advertisement
Table of Contents
