Identifying System Devices; Adding Non-Communicating Outdoor Unit And Accessories; Outdoor Unit (Air Conditioner Or Heat Pump) - Lennox iComfort G71MPP-03 Setup Manual

IDENTIFYING SYSTEM DEVICES

From the "system devices" screen, use arrow buttons to scroll to a device; then press the about button. Use the up/down arrows to scroll through and view additional information
about the selected device. When finished viewing, press the back button.
system devices
System
Heat Pump
Furnace
Thermostat
9:39 am Aug 15, 2012

ADDING NON-COMMUNICATING OUTDOOR UNIT AND ACCESSORIES

OUTDOOR UNIT (AIR CONDITIONER OR HEAT PUMP)

System Devices
System
Furnace
non-communicating device list
Outdoor Unit Type
Humidifier
Dehumidifier
Outdoor Unit Type
Select one
Not Installed
2 Stage A/C Unit
2 Stage HP Unit 3a
save
507152-01
press 'about' for
more information on
a highlighted device
back
Add or Remove
1
Non-communicating
equipment?
to add/remove/adjust a device,
select it, then press edit
current value:
Not Installed
2a
back
2b
non-communicating device list
back
1 Stage A/C Unit
Outdoor Unit Type
Outdoor Unit Capacity
1 Stage HP Unit
Outdoor Unit 1st Stage Capacity
Humidifier
Dehumidifier
cancel
3b
9:39 am Aug 15, 2012
Figure 6. Add Non-Communicating Device — Outdoor Unit
device feature list
Language Support
about
Equipment Type Name
Unit Model Number
Unit Serial Number
Unit Nominal Capacity
Number of Heating Stages
Heating Capacity by Stage
Indoor Blower CFM Range
next
Control Software Revision
Control Model Number
To add (or remove) an outdoor unit that is not icomfortt-enabled, you must be at
the "Add or Remove Non-communicating equipment?" screen.
yes
1.Press the yes button on this screen (see 1).
2.In the "non-communicating device list" screen, use the arrows (2a) to
highlight Outdoor Unit Type and press edit (2b).
3.Touch one of the radio buttons (3a) to select a 1-or 2-Stage AC Unit or a
1-or 2-Stage HP Unit; press save (3b).
4.Use arrows (4a) to highlight any red colored text in the device list (e.g.
select Outdoor Unit Capacity; text turns white). Press edit (4b).
5.Use arrows (5a) to make changes; press save (5b). Change other red
settings (if present) using a similar process.
NOTE - If the defaults are correct, you do not have to make any changes, but you
must press save (5b). When all red text is gone, the back button will appear; press
next
it to return to the "Add or Remove Non-communicating equipment?" screen (1).
edit
to add/remove/adjust a device,
select it, then press edit
current value:
2 Stage AC Unit
4a
please view and save all
red settings
Page 4
device description
Furnace
Equipment Type Name
Furnace
back
Outdoor Unit Capacity
Range is 18 to 60
edit
Default is 36, inc:1
4b set-to
36
back
save
5b
(returns to
system
devices
screen)
5a
cancel
7/2013