Warning Oil Pressure Fault - Ransomes MT503 Quick Start Manual

VISUAL DISPLAY
WARNING SLOPE ANGLE - STOP CUT
If the slope angle continues to increase the
screen will display this warning which
indicates that the cutters have been switched
off and disabled. An audible warning will
sound continuously for 4 seconds at 4
second intervals, and the red LEDs will flash
continuously for 4 seconds at 4 second
intervals. This will continue until the machine
has been driven to an area with a shallower
slope angle.
The warning screen and the audible alarm
will self-clear as the vehicle angle decreases
(i.e. the operator does not need to press
Button 4 to clear it). The angle at which this
warning occurs varies with machine
configuration as follows:
• MT503 with ROPS – 24°
• MT503 with Cab – 21°
25
1/1
QUICK START GUIDE

WARNING OIL PRESSURE FAULT

When this screen is shown, the engine oil
pressure has decreased below the normal
level. If this happens during operation, or
does not go off when the engine is run at
more than 1000 rpm. Stop the engine and
check the oil level. Top up if necessary.
1/1
en-25